Gorilla Super Glue Gel
Gorilla Glue · cyanoacrylate
Full cure (70°F / 50% RH)
24h
Min application temp
65°F
Clamp time
1 min
Open time
1 min
Dry to touch
1 min
Estimate Cure Time
Common use-case guides
When this estimate may be unsafe
- - The joint, bead, pour, or repair is thicker than the product data sheet assumes.
- - The substrate is colder than the surrounding air, wet, oily, dusty, painted, or otherwise poorly prepared.
- - The repair will carry weight, resist water pressure, or be safety-critical before full cure.
Compare with similar products
Quick answers
How long does Gorilla Super Glue Gel take to cure?
Gorilla Super Glue Gel fully cures in 24 hours at standard laboratory conditions, usually 70°F / 21°C and 50% relative humidity. At colder temperatures or difficult humidity, cure time can increase significantly.
What is the minimum temperature to use Gorilla Super Glue Gel?
The minimum application temperature for Gorilla Super Glue Gel is 65°F (18°C). Applying below this threshold can prevent proper curing and cause the bond or seal to fail.
How long does Gorilla Super Glue Gel take to cure in cold weather?
Cold temperatures significantly extend cure time. As a rule of thumb, every 18°F (10°C) below 70°F can roughly double cure time. Enter your actual temperature in the calculator for a product-specific estimate.
Does humidity affect Gorilla Super Glue Gel cure time?
Yes. Gorilla Super Glue Gel needs atmospheric moisture to trigger its cure reaction. Below 30% RH curing will stall. Above 80% RH premature surface skinning can prevent interior cure. Optimal range is 40-70% RH.
How long do you need to clamp Gorilla Super Glue Gel?
Gorilla Super Glue Gel requires a minimum of 1 minutes of clamping at standard conditions. In cold or humid conditions, extend clamp time before moving the assembly.
What is the open time for Gorilla Super Glue Gel?
Gorilla Super Glue Gel has a working open time of 1 minutes at standard conditions. At higher temperatures open time may shorten; at lower temperatures cure may slow after assembly.