Original Cold-Weld Twin Tube
J-B Weld · epoxy
Full cure (70°F / 50% RH)
24h
Min application temp
40°F
Clamp time
360 min
Open time
30 min
Estimate Cure Time
Common use-case guides
When this estimate may be unsafe
- - The joint, bead, pour, or repair is thicker than the product data sheet assumes.
- - The substrate is colder than the surrounding air, wet, oily, dusty, painted, or otherwise poorly prepared.
- - The repair will carry weight, resist water pressure, or be safety-critical before full cure.
- - The surface is near the dew point or humidity is high enough to create amine blush.
Compare with similar products
Quick answers
How long does Original Cold-Weld Twin Tube take to cure?
Original Cold-Weld Twin Tube fully cures in 24 hours at standard laboratory conditions, usually 70°F / 21°C and 50% relative humidity. At colder temperatures or difficult humidity, cure time can increase significantly.
What is the minimum temperature to use Original Cold-Weld Twin Tube?
The minimum application temperature for Original Cold-Weld Twin Tube is 40°F (4°C). Applying below this threshold can prevent proper curing and cause the bond or seal to fail.
How long does Original Cold-Weld Twin Tube take to cure in cold weather?
Cold temperatures significantly extend cure time. As a rule of thumb, every 18°F (10°C) below 70°F can roughly double cure time. Enter your actual temperature in the calculator for a product-specific estimate.
Does humidity affect Original Cold-Weld Twin Tube cure time?
Minimal effect. Original Cold-Weld Twin Tube is a two-part chemical reaction so ambient humidity has little influence on cure rate. Temperature is the primary variable. Use the calculator above for adjusted estimates.
How long do you need to clamp Original Cold-Weld Twin Tube?
Original Cold-Weld Twin Tube requires a minimum of 360 minutes of clamping at standard conditions. In cold or humid conditions, extend clamp time before moving the assembly.
What is the open time for Original Cold-Weld Twin Tube?
Original Cold-Weld Twin Tube has a working open time of 30 minutes at standard conditions. At higher temperatures open time may shorten; at lower temperatures cure may slow after assembly.
Does Original Cold-Weld Twin Tube get amine blush?
Yes. Amine blush can form when this epoxy cures in high humidity or near the dew point. Wash the surface and lightly abrade before recoating or bonding over it.