How long does Epoxy Weld Bonding Compound take to cure on Metal (Steel / Aluminium)?

Epoxy Weld Bonding Compound takes 24 hours to fully cure on Metal (Steel / Aluminium) at 70°F and 50% RH. Temperature and humidity significantly affect this — use the calculator on this page for an adjusted estimate at your actual conditions.

How do I prepare Metal (Steel / Aluminium) before applying Epoxy Weld Bonding Compound?

Degrease with isopropyl alcohol or acetone immediately before bonding — oils from handling prevent adhesion. Abrade the bonding surface with 80-grit sandpaper for maximum bite.

Epoxy

Epoxy Weld Bonding Compound on Metal (Steel / Aluminium)

Loctite · Epoxy

Ferrous and non-ferrous metal surfaces. Use the calculator below to get a cure-time estimate adjusted for your actual temperature and humidity, then follow the surface-prep checklist.

Full cure (70°F / 50% RH)

24h

Min application temp

39°F

Open / working time

6 min

Clamp / tack time

15 min

Estimate Cure Time

Surface Prep — Metal (Steel / Aluminium)

1Degrease with isopropyl alcohol or acetone immediately before bonding — oils from handling prevent adhesion.
2Abrade the bonding surface with 80-grit sandpaper for maximum bite.
3Aluminium develops an oxide layer rapidly — sand and bond within 30 minutes.
4Avoid bonding galvanised steel with construction adhesives unless the adhesive specifically supports it.

Safety Warnings

Amine blush risk: At high humidity this epoxy may form a waxy surface film. The calculator will flag this if your conditions trigger it.

Epoxy Weld Bonding Compound on other surfaces

on Concrete on Glass on Ceramic / Porcelain Tile on Plastic (ABS / Polypropylene)on Oak

← Back to Epoxy Weld Bonding Compound full page

Data sourced from manufacturer's Technical Data Sheet. Last verified: May 2026.

Important: Results are estimates only. Always follow manufacturer instructions. Not suitable for structural, load-bearing, or safety-critical applications.