PL 375 Heavy Duty Construction Adhesive
Loctite · PVA construction
Full cure (70°F / 50% RH)
48h
Min application temp
40°F
Max application temp
100°F
Open time
60 min
Estimate Cure Time
When this estimate may be unsafe
- - The joint, bead, pour, or repair is thicker than the product data sheet assumes.
- - The substrate is colder than the surrounding air, wet, oily, dusty, painted, or otherwise poorly prepared.
- - The repair will carry weight, resist water pressure, or be safety-critical before full cure.
Compare with similar products
Quick answers
How long does PL 375 Heavy Duty Construction Adhesive take to cure?
PL 375 Heavy Duty Construction Adhesive fully cures in 48 hours at standard laboratory conditions, usually 70°F / 21°C and 50% relative humidity. At colder temperatures or difficult humidity, cure time can increase significantly.
What is the minimum temperature to use PL 375 Heavy Duty Construction Adhesive?
The minimum application temperature for PL 375 Heavy Duty Construction Adhesive is 40°F (4°C). Applying below this threshold can prevent proper curing and cause the bond or seal to fail.
How long does PL 375 Heavy Duty Construction Adhesive take to cure in cold weather?
Cold temperatures significantly extend cure time. As a rule of thumb, every 18°F (10°C) below 70°F can roughly double cure time. Enter your actual temperature in the calculator for a product-specific estimate.
Does humidity affect PL 375 Heavy Duty Construction Adhesive cure time?
Yes. PL 375 Heavy Duty Construction Adhesive cures by water evaporation, so high humidity slows cure. Above 85% RH cure may fail entirely. Low humidity below 40% RH speeds drying but can cause the adhesive to dry before a proper bond forms. Optimal range is 40-60% RH.
What is the open time for PL 375 Heavy Duty Construction Adhesive?
PL 375 Heavy Duty Construction Adhesive has a working open time of 60 minutes at standard conditions. At higher temperatures open time may shorten; at lower temperatures cure may slow after assembly.
What happens if I use PL 375 Heavy Duty Construction Adhesive below 39°F?
PL 375 Heavy Duty Construction Adhesive has a minimum film-forming temperature of 4°C (39°F). Below this temperature, the adhesive can dry chalky or weak instead of forming a proper film.