How long does PL 500 Landscape Construction Adhesive take to cure on Concrete?

PL 500 Landscape Construction Adhesive takes 168 hours to fully cure on Concrete at 70°F and 50% RH. Temperature and humidity significantly affect this — use the calculator on this page for an adjusted estimate at your actual conditions.

How do I prepare Concrete before applying PL 500 Landscape Construction Adhesive?

Concrete must be fully cured (minimum 28 days) before bonding anything to it. Clean off oil, paint, curing compounds, and efflorescence. Use acid etching or mechanical grinding for smooth slabs.

Construction Adhesive

PL 500 Landscape Construction Adhesive on Concrete

Loctite · Construction Adhesive

Portland cement-based cast or pre-cast concrete. Use the calculator below to get a cure-time estimate adjusted for your actual temperature and humidity, then follow the surface-prep checklist.

Full cure (70°F / 50% RH)

168h

Min application temp

0°F

Open / working time

15 min

Clamp / tack time

1440 min

Estimate Cure Time

Surface Prep — Concrete

1Concrete must be fully cured (minimum 28 days) before bonding anything to it.
2Clean off oil, paint, curing compounds, and efflorescence. Use acid etching or mechanical grinding for smooth slabs.
3Concrete is porous — pre-wet slightly for construction adhesives to prevent the concrete from pulling moisture out too quickly.
4Cold concrete significantly slows adhesive cure — warm the slab above 50°F (10°C) before applying.

PL 500 Landscape Construction Adhesive on other surfaces

on Brick on Metal (Steel / Aluminium)on Drywall (Gypsum Board)on Foam Insulation (EPS / XPS)

← Back to PL 500 Landscape Construction Adhesive full page

Data sourced from manufacturer's Technical Data Sheet. Last verified: May 2026.

Important: Results are estimates only. Always follow manufacturer instructions. Not suitable for structural, load-bearing, or safety-critical applications.