How long does Titebond II Premium Wood Glue take to cure on Pine?

Titebond II Premium Wood Glue takes 24 hours to fully cure on Pine at 70°F and 50% RH. Temperature and humidity significantly affect this — use the calculator on this page for an adjusted estimate at your actual conditions.

How do I prepare Pine before applying Titebond II Premium Wood Glue?

End grain absorbs adhesive heavily — apply two thin coats with a 2-minute wait between to prevent a starved joint. Sand face grain to 120-grit. Do not use 220-grit or finer as it seals the fibers.

Wood Glue

Titebond II Premium Wood Glue on Pine

Franklin International · Wood Glue

Softwood (ponderosa, white, yellow pine). Use the calculator below to get a cure-time estimate adjusted for your actual temperature and humidity, then follow the surface-prep checklist.

Full cure (70°F / 50% RH)

24h

Min application temp

55°F

Open / working time

5 min

Clamp / tack time

30 min

Estimate Cure Time

Surface Prep — Pine

1End grain absorbs adhesive heavily — apply two thin coats with a 2-minute wait between to prevent a starved joint.
2Sand face grain to 120-grit. Do not use 220-grit or finer as it seals the fibers.
3Pine resin pockets can prevent bonding — route them out or seal with shellac before gluing.
4Keep boards in the work space for 24 hours before gluing so moisture content stabilises.

Safety Warnings

Cold-temperature chalking risk: Below 13°C (55°F) this adhesive may dry powdery with near-zero strength.

Titebond II Premium Wood Glue on other surfaces

on Oak on MDF (Medium-Density Fiberboard)on Plywood on Bamboo

← Back to Titebond II Premium Wood Glue full page

Data sourced from manufacturer's Technical Data Sheet. Last verified: June 2026.

Important: Results are estimates only. Always follow manufacturer instructions. Not suitable for structural, load-bearing, or safety-critical applications.