Titebond Quick & Thick Multi-Surface Glue
Franklin International · PVA
Full cure (70°F / 50% RH)
24h
Min application temp
50°F
Clamp time
30 min
Open time
5 min
Estimate Cure Time
Common use-case guides
When this estimate may be unsafe
- - The joint, bead, pour, or repair is thicker than the product data sheet assumes.
- - The substrate is colder than the surrounding air, wet, oily, dusty, painted, or otherwise poorly prepared.
- - The repair will carry weight, resist water pressure, or be safety-critical before full cure.
Compare with similar products
Quick answers
How long does Titebond Quick & Thick Multi-Surface Glue take to cure?
Titebond Quick & Thick Multi-Surface Glue fully cures in 24 hours at standard laboratory conditions, usually 70°F / 21°C and 50% relative humidity. At colder temperatures or difficult humidity, cure time can increase significantly.
What is the minimum temperature to use Titebond Quick & Thick Multi-Surface Glue?
The minimum application temperature for Titebond Quick & Thick Multi-Surface Glue is 50°F (10°C). Applying below this threshold can prevent proper curing and cause the bond or seal to fail.
How long does Titebond Quick & Thick Multi-Surface Glue take to cure in cold weather?
Cold temperatures significantly extend cure time. As a rule of thumb, every 18°F (10°C) below 70°F can roughly double cure time. Enter your actual temperature in the calculator for a product-specific estimate.
Does humidity affect Titebond Quick & Thick Multi-Surface Glue cure time?
Yes. Titebond Quick & Thick Multi-Surface Glue cures by water evaporation, so high humidity slows cure. Above 85% RH cure may fail entirely. Low humidity below 40% RH speeds drying but can cause the adhesive to dry before a proper bond forms. Optimal range is 40-60% RH.
How long do you need to clamp Titebond Quick & Thick Multi-Surface Glue?
Titebond Quick & Thick Multi-Surface Glue requires a minimum of 30 minutes of clamping at standard conditions. In cold or humid conditions, extend clamp time before moving the assembly.
What is the open time for Titebond Quick & Thick Multi-Surface Glue?
Titebond Quick & Thick Multi-Surface Glue has a working open time of 5 minutes at standard conditions. At higher temperatures open time may shorten; at lower temperatures cure may slow after assembly.
What happens if I use Titebond Quick & Thick Multi-Surface Glue below 50°F?
Titebond Quick & Thick Multi-Surface Glue has a minimum film-forming temperature of 10°C (50°F). Below this temperature, the adhesive can dry chalky or weak instead of forming a proper film.