How long does Titebond Instant Bond Medium Jet Black take to cure on Plastic (ABS / Polypropylene)?

Titebond Instant Bond Medium Jet Black takes 8 hours to fully cure on Plastic (ABS / Polypropylene) at 70°F and 50% RH. Temperature and humidity significantly affect this — use the calculator on this page for an adjusted estimate at your actual conditions.

How do I prepare Plastic (ABS / Polypropylene) before applying Titebond Instant Bond Medium Jet Black?

Lightly scuff with 220-grit sandpaper to increase surface area, then clean with isopropyl alcohol. Polyethylene (PE) and polypropylene (PP) have very low surface energy — most adhesives will not bond permanently without a flame-treatment or special primer.

Construction Adhesive

Titebond Instant Bond Medium Jet Black on Plastic (ABS / Polypropylene)

Franklin International · Construction Adhesive

Common thermoplastics. Use the calculator below to get a cure-time estimate adjusted for your actual temperature and humidity, then follow the surface-prep checklist.

Full cure (70°F / 50% RH)

Min application temp

50°F

Open / working time

1 min

Clamp / tack time

1 min

Estimate Cure Time

Surface Prep — Plastic (ABS / Polypropylene)

1Lightly scuff with 220-grit sandpaper to increase surface area, then clean with isopropyl alcohol.
2Polyethylene (PE) and polypropylene (PP) have very low surface energy — most adhesives will not bond permanently without a flame-treatment or special primer.
3ABS and PVC bond well with structural adhesives after sanding.
4Do not use solvents like acetone on ABS — it will dissolve the surface.

Titebond Instant Bond Medium Jet Black on other surfaces

on Metal (Steel / Aluminium)on Glass on Ceramic / Porcelain Tile on Natural Stone

← Back to Titebond Instant Bond Medium Jet Black full page

Data sourced from manufacturer's Technical Data Sheet. Last verified: June 2026.

Important: Results are estimates only. Always follow manufacturer instructions. Not suitable for structural, load-bearing, or safety-critical applications.